AudioCodes Mediant 2000 Manual do Utilizador descarregar pdf (Página 49)

12. Message Waiting Indicator (MWI)

• Although Exchange 2007 UM does not natively support MWI, Geomant has created a 3rd party

solution - MWI2007. This product also supports SMS message notification.

• Installation files and product documentation can be found on Geomant’s

MWI 2007 website.

13. Test-UMConnectivity

• Run the Test-UMConnectivity diagnostic cmdlet by executing the following command in

Exchange Management Shell:

• Test-UMConnectivity –UMIPGateway:<Gateway> -Phone:<Phone> |fl

• <Gateway> is the name (or IP address) of the gateway which is connected to UM, and

through which you want to check the connectivity to the UM server. Make sure the gateway is

configured to route calls to UM.

• <Phone> is a valid UM extension. First, try using the UM pilot number for the hunt-group

linked to the gateway. Next, try using a CFNA number configured for the gateway. Please

ensure that a user or an AA is present on the UM server with that number.

• The output shows the latency and reports if it was successful or there were any errors.

14. Test Fail-Over Configuration on IP-PBX with Two UM Servers

• This is only required for direct SIP integration with IP-PBX. If the IP-PBX supports fail-over

configuration (e.g., round-robin calls between two or more UM servers):

a. Provide the configuration steps in Section 5.

b. Configure the IP-PBX to work with two UM servers.

c. Simulate a failure in one UM server.

d. Confirm the IP-PBX transfers new calls to the other UM server successfully.

1 2 ... 44 45 46 47 48 49

Sem comentários

AudioCodes Mediant 2000 Manual do Utilizador Página 49