
Description of more significant .ini parameters. This is not a comprehensive list of all
parameters found in the .ini file. A bold face parameter name indicates that it should be
changed to represent specific site information.
Sets the 4 TOS layer 3 bits.
Values: 0 through 15
Example: IPTOS = 0
Specifies transport mechanism for DTMF tones
Values:
0 (erase digits and do not relay)
1 (erase digits and relay to remote – proprietary)
2 (digits remain in voice stream – inband)
3 (erase digits and relay using RFC2833)
Example: DTMFTransportType = 3
Payload number to use for RFC2833 packets. This
value is only used when DTMFTransportType = 3.
Values: 96-99, 105-127
Which coders should be used. Each coder will be
on its own line. Up to 5 can be given. The first
one specified is given precedence.
Values:
g711Ulaw64k,20
g711Alaw64k,20
g729
g7231
g726
Note: This line can be specified multiple times.
Example:
;first coder used
CoderName = g711Ulaw64k,20
; second coder used
CoderName = g7231
Using a Proxy (or Interaction Center Server) for all
calls?
Values:
0 (no, using the Prefix Routing Table)
1 (yes, the proxy is in the ProxyIP field)
Example: IsProxyUsed = 1
Proxy or Interaction Center Server IP address (if
IsProxyUsed=1).
Note: If a proxy is not used then the Prefix Routing
Table is used.
Example: ProxyIp = 172.16.129.160
First Redundant Proxy (for a failover scenario)
Values:
0 (Parking – gateway will continue to send calls
to the last good proxy)
1 (Homing – gateway will always send calls to
the proxies in order, starting with the primary)
Whether to register.
Values: 0 (no), 1 (yes)
Example: IsRegisterNeeded = 0
Proxy Server Name. Used in host portion in the SIP
address in the To header.
Example: ProxyName = ICServer1.inin.com
Comentários a estes Manuais