AudioCodes MP-204B Manual do Utilizador

1 NetVanta Unified Communications Technical Note ___________________________________________________________________________________ Installing an

10 5. Submit Backing up the Configuration It is important to back up the system configuration once the gateway is configured. Go to Maintenance. Cl

11 Toll Restrictions Configure the toll restrictions to match the requirements of your organization. Consult the NetVanta Unified Communications Se

2 Overview of Procedure The M1K must be connected to the internal LAN (a 100 Mbps connection is recommended) and 1 to 8 trunks. The MP-11x has two c

3 To confirm the software revision for your gateway, navigate to Status and Diagnostics -> Device Information and ensure that the gateway softwar

4 Configuring SIP When the gateway receives a call from the PSTN it must know where to send that call. In the reverse direction, the gateway must ac

5 7. Go to Protocol Management -> Routing Tables -> Tel to IP Routing. 8. Enter a row that has Dest. IP Address set to the UC server IP addr

6 11. Go to Advanced Configuration -> Media Settings -> Fax/Modem/CID Settings and ensure that: Fax Transport Mode is T.38 Relay. V.21 Mod

7 See Figure 6 below. Figure 6 – With these settings any incoming call is routed to 10000. Outgoing A gateway may have more physical trunks than ar

8 See Figure 8 below. Figure 8 Outgoing DID Presentation When an outgoing call to the PSTN is made over an analog trunk, the caller ID is generated

9 See Figure 9 below. Figure 9 POTS The basic settings in the gateway should be sufficient for most cases. 1. Go to Protocol Management -> Adva