AudioCodes MP-102 Manual do Utilizador descarregar pdf (Página 5)

VoiceDirector Device Configuration Guide AudioCodes MP-102/104/108 FXO & MP-102/104/108 FXS

VIA THE CONSOLE

You can also view the IP address using the console port on the device.

To view the IP address using the console port on the device:

1. With a standard RS-232 straight cable (not a cross-over) with DB-9

connectors, connect the MP-1xx RS232 port to either COM1 or COM2

RS-232 port on the PC. The connector pinout and gender are shown

below.

2. On a PC running Windows, run HyperTerminal by clicking the Start

button, and then clicking Accessories: Communications:

HyperTerminal.

3. Enter a name for new connection, and click OK.

4. Select communication port COM1 or COM2, and click OK.

5. In the COM1/2 Property dialog box, enter the following settings:

 Baud Rate: 115,200 bps

 Data bits: 8

 Parity: None

 Stop bits: 1

 Flow control: Hardware

6. Click the OK button.

The Hyper Terminal main screen opens.

7. Reboot the device.

At beginning of the boot cycle, the device displays the IP address in the

HyperTerminal window.

Upgrading the Device

To upgrade the device:

1. Copy MP108_SIP_F4.40.193.350.cmp from the installation package to

your PC desktop.

2. Connect to the MP-10x FXO by entering the device’s IP address in the

Address bar of your PC’s Web browser. For instructions on obtaining the

IP address, refer to Accessing the Device in the AudioCodes MP-

102/104/108 FXO Configuration Guide section on page Error!

Bookmark not defined. of the Appendix.

3. Click on Software Update on the left, and then click the Software

Upgrade Wizard tab.

The Software Update Wizard window displays.

4. Click the Start Software Upgrade button.

Page 2

1 2 3 4 5 6 7 8 9 10 ... 19 20

Sem comentários

AudioCodes MP-102 Manual do Utilizador Página 5