AudioCodes MEDIAPACK VERSION 6.2 Manual do Utilizador descarregar pdf (Página 32)

MediaPack BRI Series

User's Manual 32 Document #: LTRT-83702

¾ To connect the MediaPack to the WAN:

1. Connect the RJ-45 connector, at the one end of the Ethernet Cat 5 cable (supplied) to

the MediaPack's WAN port (labeled WAN).

2. Connect the other end of the cable to the WAN network.

Figure 3-6: MediaPack LAN and WAN Cabling

3.4.3 Connecting the ISDN BRI S/T Interface

The MediaPack provides up to four BRI S/T interface ports (depending on MediaPack

model -- refer to Table 1-1 on page 15) for connecting ISDN terminal equipment such as

ISDN telephones. Up to eight terminal equipment (TE) devices can be connected per BRI

S/T port by using an ISDN S-bus that provides eight ISDN ports.

The ISDN cabling requirements are as follows:

 Connector: 8-pin RJ-45.

 Connector Pinouts: refer to Table 3-1 and Figure 3-7 below.

Table 3-1: RJ-45 Pinouts for ISDN S/T Interface

Description Pin Color

User Side Network Side

3 White / Green Tx+ Rx+

4 Blue Rx+ Tx+

5 White / Blue Rx- Tx-

6 Green Tx- Rx+

Note: Pins 1, 2, 7, and 8 are not connected.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 179 180

Sem comentários

AudioCodes MEDIAPACK VERSION 6.2 Manual do Utilizador Página 32