AudioCodes MediaPack MP-124 Manual do Utilizador descarregar pdf (Página 62)

Microsoft Lync Server 2013 62 Document #: LTRT-40127

Enhanced Gateway with Analog Devices

4.14 Step 14: Configuring Normalization Rules for E.164

Format for PBX/PSTN Connectivity

Microsoft Lync 2013 implements the standard E.164 format, while the PBX or PSTN

implements other number formats for dialing. If the Enhanced gateway is connected to a

PBX or directly to the PSTN, the Enhanced gateway may need to perform number

manipulations for the called and/or calling number to match the PBX or PSTN dialing rules

or to match Microsoft Lync 2013 E.164 format.

Therefore, the gateway entity must be configured with manipulation rules to translate (i.e.,

normalize) numbers dialed in standard E.164 format to various formats, and vice versa.

Manipulation needs to be done for outbound calls (i.e., calls received from Microsoft Lync

clients through Microsoft Lync 2013) and inbound calls (i.e., calls destined to Lync clients).

Number manipulation (and mapping of NPI/TON to SIP messages) rules are configured in

the following Manipulation tables:



For Tel-to-IP calls:

• Destination Phone Number Manipulation Table for Tel-to-IP Calls

• Source Phone Number Manipulation Table for Tel-to-IP Calls



For IP-to-Tel calls:

• Destination Phone Number Manipulation Table for IP-to-Tel Calls

• Source Phone Number Manipulation Table for IP-to-Tel Calls

Number manipulation configuration examples are provided for inbound and outbound calls

in Section 4.14.1.

 To configure number manipulation rules:

1. Open the required Number Manipulation page (Configuration tab > VoIP menu >

GW and IP to IP submenu > Manipulations > Dest Number IP->Tel or Dest

Number Tel->IP or Source Number IP->Tel or Source Number Tel->IP); the

relevant Manipulation table page is displayed.

2. Click the Add button; the following dialog box appears:

Figure 4-39: Example Dest Number IP->Tel Number Manipulation Rule

3. Click the Rule tab, and then configure the matching characteristics.

4. Click the Action tab, and then configure the manipulation operation.

5. Click Submit to apply your changes.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 97 98

Sem comentários

AudioCodes MediaPack MP-124 Manual do Utilizador Página 62