AudioCodes MediaPack 114 Manual do Utilizador descarregar pdf (Página 142)

SIP User's Manual 142 Document #: LTRT-65411

MediaPack Series

Parameter Description

If the Caller ID service is enabled, then for FXS interfaces, calling

number and Display text (from IP) are sent to the device's port.

For FXO interfaces, the Caller ID signal is detected and sent to IP in the

SIP INVITE message (as 'Display' element).

For information on the Caller ID table, refer to “Caller ID” on page 177.

To disa

ble/enable caller ID generation per port, refer to “Call Forward”

on page 178.

Caller ID Type

[CallerIDType]

Defines one of the following standards for detection (FXO) and

generation (FXS) of Caller ID, and detection (FXO) generation (FXS) of

MWI (when specified) signals:

 [0] Standard Bellcore = Caller ID and MWI (default)

 [1] Standard ETSI = Caller ID and MWI

 [2] Standard NTT

 [4] Standard BT = Britain

 [16] Standard DTMF Based ETSI

 [17] Standard Denmark = Caller ID and MWI

 [18] Standard India

 [19] Standard Brazil

Notes:

 Typically, the Caller ID signals are generated/detected between the

first and second rings. However, sometimes the Caller ID is detected

before the first ring signal (in such a scenario, configure

RingsBeforeCallerID to 0).

 Caller ID detection for Britain [4] is not supported on the device’s

FXO ports. Only FXS ports can generate the Britain [4] Caller ID.

 To select the Bellcore Caller ID sub standard, use the parameter

BellcoreCallerIDTypeOneSubStandard. To select the ETSI Caller ID

substandard, use the parameter ETSICallerIDTypeOneSubStandard.

 To select the Bellcore MWI sub standard, use the parameter

BellcoreVMWITypeOneStandard. To select the ETSI MWI sub

standard, use the parameter ETSIVMWITypeOneStandard.

Hook-Flash Code

[HookFlashCode]

Determines a digit pattern that when received from the Tel side,

indicates a Hook Flash event.

The valid range is a 25-character string. The default is a null string.

Message Waiting Indication (MWI) Parameters

Enable MWI

[EnableMWI]

Enables Message Waiting Indication (MWI).

 [0] Disable = Disabled (default).

 [1] Enable = MWI service is enabled.

Notes:

 This parameter is applicable only to FXS interfaces.

 The device supports only the receipt of SIP MWI NOTIFY messages

(the device doesn't generate these messages).

 For detailed information on MWI, refer to “Message Waiting

Indication” on page 361.

1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 389 390

Comentários a estes Manuais

Sem comentários

AudioCodes MediaPack 114 Manual do Utilizador Página 142

Comentários a estes Manuais

Manuais e produtos relacionados com Gateways/controladores AudioCodes MediaPack 114