AudioCodes MediaPack 114 Manual do Utilizador Página 164

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 390
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 163
SIP User's Manual 164 Document #: LTRT-65411
MediaPack Series
3.4.4.4.3 IP to Trunk Group Routing Table
The 'IP to Hunt Group Routing Table' page provides a table for routing incoming IP calls to
groups of channels (FXS/FXO endpoints)called Hunt Groups. Hunt Group ID's are assigned
to the device's channels in the 'Endpoint Phone Number' page (refer to “Configuring the
Endpoint Phone Numbers” on page 181). You ca
n add up to 24 IP-to-Hunt Group routing
rules in the table.
Note: The 'IP to Hunt Group Routing Table' page appears only if the parameter
EnableSBC is set to 0 (default) in SBC Configuration. If this parameter is
enabled, the 'Inbound IP Routing Table' page appears instead (refer to
Inbound IP Routing Table for a description of this page).
The IP-to-Tel calls are routed to Hunt Groups according to any one of the following (or a
combination thereof) criteria:
Destination and source host prefix
Destination and source phone prefix
Source IP address
Once the call is routed to the specific Hunt Group, the call is sent to the device's channels
pertaining to that Hunt Group. The specific channel within the Hunt Group to which the call
is sent is determined according to the Hunt Group's channel selection mode. This channel
selection mode can be defined per Hunt Group (refer to ''Configuring the Trunk Group
Settings'' on page 183) o
r for all Hunt Groups using the global parameter
ChannelSelectMode.(refer to ''SIP General Parameters'' on page 101).
Notes:
When a call release reason (defined in ''Reasons for Alternative Routing''
on page 168) is received for a specific IP-to-Tel call, an alternative Hunt
Group for that call can be configured. This is performed by assigning the
call to an additional routing rule in the table (i.e., repeat the same routing
rule, but with a different Hunt Group ID).
You can also configure the 'IP to Hunt Group Routing' table using the ini
file table parameter PSTNPrefix (refer to ''Number Manipulation and
Routing Parameters'' on page 289).
¾ To configure the IP to Hunt Group Routing table, take these 5
steps:
1. Open the 'IP to Hunt Group Routing' page (Configuration tab > Protocol
Configuration menu > Routing Tables submenu > IP to Hunt Group Routing page
item).
Vista de página 163
1 2 ... 159 160 161 162 163 164 165 166 167 168 169 ... 389 390

Comentários a estes Manuais

Sem comentários