AudioCodes MediaPack 114 Manual do Utilizador descarregar pdf (Página 348)

SIP User's Manual 348 Document #: LTRT-65411

MediaPack Series

7.13.4 Remote PBX Extension Between FXO and FXS Devices

Remote PBX extension offers a company the capability of extending the "power" of its local

PBX by allowing remote phones (remote offices) to connect to the company's PBX over the

IP network (instead of via PSTN). This is as if the remote office is located in the head office

(where the PBX is installed). PBX extensions are connected through FXO ports to the IP

network, instead of being connected to individual telephone stations. At the remote office,

FXS units connect analog phones to the same IP network. To produce full transparency,

each FXO port is mapped to an FXS port (i.e., one-to-one mapping). This allows individual

extensions to be extended to remote locations. To call a remote office worker, a PBX user

or a PSTN caller simply dials the PBX extension that is mapped to the remote FXS port.

This section provides an example on how to implement a remote telephone extension

through the IP network, using 8-port FXO and 8-port FXS devices. In this configuration, the

FXO device routes calls received from the PBX to the ‘Remote PBX Extension’ connected

to the FXS device. The routing is transparent as if the telephone connected to the FXS

device is directly connected to the PBX.

The following is required:

 One FXO device with ports connected directly to the PBX lines (shown in the figure

below)

 One FXS device for the 'remote PBX extension'

 Analog phones (POTS)

 PBX (one or more PBX loop start lines)

 LAN network

Figure 7-10: FXO-FXS Remote PBX Extension (Example)

1 2 ... 343 344 345 346 347 348 349 350 351 352 353 ... 389 390

Sem comentários

AudioCodes MediaPack 114 Manual do Utilizador Página 348