AudioCodes MediaPack 114 Manual do Utilizador descarregar pdf (Página 271)

Version 5.6 271 November 2008

SIP User's Manual 4. ini File Configuration

Parameter Description

RTPOnlyMode

For a description of this parameter, refer to ''Advanced

Parameters'' on page 129.

TimeoutBetween100And18x

Defines the timeout (in msec) between receiving a 100 Trying

response and a subsequent 18x response. If a 18x response is

not received before this timer expires, the call is disconnected.

The valid range is 0 to 32,000. The default value is 0 (i.e., no

timeout).

RxDTMFOption

For a description of this parameter, refer to ''DTMF & Dialing

Parameters'' on page 125.

TxDTMFOption

This ini file table parameter determines a single or several (up to

5) preferred transmit DTMF negotiation methods.

The format of this parameter is as follows:

[TxDTMFOption]

FORMAT TxDTMFOption_Index = TxDTMFOption_Type;

[\TxDTMFOption]

For example:

[TxDTMFOption]

TxDTMFOption 0 = 1;

[\TxDTMFOption]

Notes:

 DTMF negotiation methods are prioritized according to the

order of their appearance.

 When out-of-band DTMF transfer is used ([1], [2], or [3]), the

parameter DTMFTransportType is automatically set to 0

(DTMF digits are erased from the RTP stream).

 When RFC 2833 ([4]) is used, the device:

1) Negotiates RFC 2833 Payload Type (PT) using local and

remote SDPs.

2) Sends DTMF packets using RFC 2833 PT according to the

PT in the received SDP.

3) Expects to receive RFC 2833 packets with the same PT as

configured by the parameter RFC2833PayloadType.

4) Uses the same PT for send and receive if the remote party

doesn't include the RFC 2833 DTMF PT in its SDP.

 When TxDTMFOption is set to [0], the RFC 2833 PT is set

according to the parameter RFC2833PayloadType for both

transmit and receive.

 For defining this parameter using the Web interface, refer to

''DTMF & Dialing Parameters'' on page 125.

 For a description on using ini file table parameters, refer to

''Structure of ini File Table Parameters'' on page 233.

DisableAutoDTMFMute

Enables / disables the automatic muting of DTMF digits when out-

of-band DTMF transmission is used.

 [0] = Automatic mute is used (default).

 [1] = No automatic mute of in-band DTMF.

When DisableAutoDTMFMute = 1, the DTMF transport type is set

according to the parameter DTMFTransportType and the DTMF

digits aren't muted if out-of-band DTMF mode is selected

(TxDTMFOption =1, 2 or 3). This enables the sending of DTMF

1 2 ... 266 267 268 269 270 271 272 273 274 275 276 ... 389 390

Comentários a estes Manuais

Sem comentários

AudioCodes MediaPack 114 Manual do Utilizador Página 271

Comentários a estes Manuais

Manuais e produtos relacionados com Gateways/controladores AudioCodes MediaPack 114