AudioCodes MediaPack 114 Manual do Utilizador descarregar pdf (Página 347)

Version 5.6 347 November 2008

SIP User's Manual 7. IP Telephony Capabilities

¾ To configure the two devices for call communication, take these 4

steps:

1. For the first device (10.2.37.10), in the ‘Endpoint Phone Number Table' page (refer to

Configuring the Endpoint Phone Numbers on page 181), assign

the phone numbers

101 to 104 to the device's endpoints.

Figure 7-7: Assigning Phone Numbers to Device 10.2.37.10

2. For the second device (10.2.37.20), in the ‘Endpoint Phone Number Table' page,

assign the phone numbers 201 to 204 to the device's endpoints.

Figure 7-8: Assigning Phone Numbers to Device 10.2.37.20

3. Configure the following settings for both devices:

In the ‘Tel to IP Routing’ page (refer to ''Tel to IP Routing Table'' on page 160), a

dd the

following routing rules:

a. In the first row, enter 10 for the destination phone prefix and enter 10.2.37.10 for

the destination IP address (i.e., IP address of the first device).

b. In the second row, enter 20 for the destination phone prefix and 10.2.37.20 for the

destination IP address (i.e., IP address of the second device).

These settings enable the routing (from both devices) of outgoing Tel-to-IP calls that

start with 10 to the first device and calls that start with 20 to the second device.

Figure 7-9: Routing Calls Between Devices

4. Make a call. Pick up the phone connected to port #1 of the first device and dial 102 (to

the phone connected to port #2 of the same device). Listen for progress tones at the

calling phone and for the ringing tone at the called phone. Answer the called phone,

speak into the calling phone, and check the voice quality. Dial 201 from the phone

connected to port #1 of the first device; the phone connected to port #1 of the second

device rings. Answer the call and check the voice quality.

1 2 ... 342 343 344 345 346 347 348 349 350 351 352 ... 389 390

Sem comentários

AudioCodes MediaPack 114 Manual do Utilizador Página 347