AudioCodes MediaPack 114 Manual do Utilizador descarregar pdf (Página 177)

Version 5.6 177 November 2008

SIP User's Manual 3. Web-Based Management

• Hotline [2]: When a phone is off-hooked and no digit is dialed for a user-defined

interval (Hotline Dial Tone Duration - refer to ''DTMF & Dialing Parameters'' on

page 125), th

e number in the 'Destination Phone Number' field is automatically

dialed (applies to FXS and FXO interfaces).

4. Click the Submit button to save your changes.

5. To save the changes to flash memory, refer to ''Saving Configuration'' on page 209.

3.4.4.6.3 Caller Display Information

The 'Caller Display Information' page allows you to enable the device to send Caller ID

information to IP when a call is made. The called party can use this information for caller

identification. The information configured in this page is sent in an INVITE message in the

'From' header. For information on Caller ID restriction according to destination / source

prefixes, refer to ''Configuring the Number Manipulation Tables'' on page 151.

¾ To configure the Caller Display Information, take these 5 steps:

1. Open the 'Caller Display Information' page (Configuration tab > Protocol

Configuration menu > Endpoint Settings submenu > Caller Display Information

page item).

Figure 3-81: Caller Display Information Page

2. In the' Caller ID/Name' field corresponding to the desired port, enter the Caller ID

string (up to 18 characters).

3. From the 'Presentation' drop-down list, select one of the following:

• 'Allowed' [0] - sends the string defined in the 'Caller ID/Name' field when a Tel-to-

IP call is made using the corresponding device port.

• 'Restricted' [1] - the string defined in the 'Caller ID/Name' field is not sent.

4. Click the Submit button to save your changes.

5. To save the changes to flash memory, refer to ''Saving Configuration'' on page 209.

1 2 ... 172 173 174 175 176 177 178 179 180 181 182 ... 389 390

Sem comentários

AudioCodes MediaPack 114 Manual do Utilizador Página 177